Central management Configuremultiple IX20 devicesbyusing Digi Remote Manager configurations
IX20 User Guide
79
7. Click Register.
The device is added to Remote Manager.
Command line
1. Log into the IX20 local command line as a user with full Admin accessrights.
2. Register a device.
(register) [group STRING] password STRING username STRING
where:
n
group: group to add device in Digi Remote Manager.
n
password: Digi Remote Manager password (required).
n
username: Digi Remote Manager username (required).
1. Click Apply to savethe configuration and apply the change.
2. Save the configuration and apply the change
(config)> save
Configuration saved.
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure multiple IX20 devices by using Digi Remote Manager
configurations
Digi recommendsyou take advantage of Remote Manager configurationsto manage multiple IX20
devices. ARemote Manager configuration is a named set of device firmware, settings, and file system
options. You use the configuration to automatically update multiple devices and to periodically scan
devices to check for compliance with the configuration. See the Digi Remote Manager User Guide for
more information about Remote Manager configurations.
Typically, if you want to provision multiple IX20 routers:
1. Using the IX20 local WebUI, configure one IX20 router to use asthe model configuration for all
subsequent IX20syou need to manage.
2. Register the configured IX20 device in your Remote Manager account.
To Next Page
Loading...
Need help?
General