User authentication Configureserial authentication
IX20 User Guide
914
12. Add an LDAPserver:
a. Add the server:
(config)> add auth ldap server end
(config auth ldap server 0)>
b. Enter the LDAPserver's IPaddress or hostname:
(config auth ldap server 0)> hostname hostname|ip-address
(config auth ldap server 0)>
c. (Optional) Change the default port setting to the appropriate port:
(config auth ldap server 0)> port port
(config auth ldap server 0)>
d. (Optional) Repeat the above stepsto add additional LDAPservers.
13. Add LDAPto the authentication methods. Authentication methodsare attempted in the order
they are listed until the first successful authentication result isreturned. Thisexample will add
LDAPto the end of the list. See User authentication methodsfor information about adding
methodsto the beginning or middle of the list.
(config)> add auth method end ldap
(config)>
14. Save the configuration and apply the change
(config)> save
Configuration saved.
>
15. Typeexit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure serial authentication
This section describeshow to configure authentication for serial access.
Web
1. Log into Digi Remote Manager, or log into the local Web UI asa user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
To Next Page
Loading...
Need help?
General