Services Location information
IX20 User Guide
713
8.1. Save the configuration and apply the change
(config)> save
Configuration saved.
>
2. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Forward location information to a remote host
You can configure location clients on the IX20 device that forward location messages in either
NMEA or TAIPformat to a remote host.
Required configuration items
n
Enable the location service.
n
The hostname or IPaddressof the remote host to which the location messageswill be
forwarded.
n
The communication protocol, either TCPor UDP.
n
The destination port on the remote host to which the messages will be forwarded.
n
Message protocol type of the messages being forwarded, either NMEAor TAIP.
Additional configuration items
n
Additional remote hoststo which the location messages will be forwarded.
n
Location update interval, which determines how often the device will forward location
information to the remote hosts.
n
Adescription of the remote hosts.
n
Specific typesof NMEAor TAIPmessages that should beforwarded.
n
If the message protocol is NMEA, configure a talker IDto be used for all messages.
n
Text that will be prepended to the forwarded message.
n
Avehicle IDthat is used in the TAIPIDmessage and can also beprepended to the forwarded
message.
Configure the IX20 device to forward location information:
Web
1. Log into Digi Remote Manager, or log into the local Web UI asa user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
b. Click the Device ID.
To Next Page
Loading...