User authentication Authentication groups
IX20 User Guide
872
Change the access rights for a predefined group
By default, two authentication groupsare predefined: admin and serial. To change the accessrights
of the predefined groups:
Web
1. Log into Digi Remote Manager, or log into the local Web UI asa user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Authentication > Groups.
4. Click the authentication group to be changed, either admin or serial, to expand its
configuration node.
5. Click the box next to the following options, asappropriate, to enable or disable access rights
for each:
n
Admin access
For groupsassigned Admin access, you can also determine whether the Access level
should beFull accessor Read-only access.
l
Full accessprovides users of this group with the ability to manage the IX20 device
by using the WebUI or the Admin CLI.
To Next Page
Loading...
Need help?
General