User authentication Authentication groups
IX20 User Guide
873
l
Read-only accessprovides users of this group with read-only access to the WebUI
and Admin CLI.
The default is Full access.
n
Serial access
n
Interactive shell access
Shell accessisnot available if the Allow shell parameter has been disabled. See Disable
shell access for more information about the Allow shell parameter.
6. Click Apply to savethe configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions> Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to accessthe Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable or disable access rights for the group. For example:
n
Admin access:
l
To set the accesslevel for Admin accessof the admin group:
(config)> auth group admin acl admin level value
(config)>
where value is either:
o
full: provides usersof thisgroup with the ability to manage the IX20 device by
using the WebUI or the Admin CLI.
To Next Page
Loading...
Need help?
General