Firmwareconfiguration Configuration methods
IX20 User Guide
53
5. Save the configuration and apply the change
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configuration methods
There are two primary methodsfor configuring your IX20 device:
n
Web interface.
The web interface can be accessed in two ways:
l
Central management using the Digi Remote Manager, a cloud-based device management
and data enablement platform that allowsyou to connect any device to any application,
anywhere. With the Remote Manager, you can configure your IX20 device and use the
configuration as a basis for a Remote Manager configuration which can beapplied to other
similar devices. See Central management for more information about using the Remote
Manager to manage and configure your IX20 device.
l
The local web interface. See Using the local web interface for more information about
using the local web interface to manage and configure your IX20 device.
Note Changes made to the device'sconfiguration by using the local web interface will not
be automatically reflected in Digi Remote Manager. You must manually refresh Remote
Manager for the changesto be displayed.
Web-based instructionsin this guide are applicable to both the Remote Manager and the local
web interface.
n
Command line.
Arobust command line allowsyou to perform all configuration and management tasksfrom
within a command shell. Both the Remote Manager and the local web interface also have the
option to open a terminal emulator for executing commandson your IX20 device. See Using
the command line for more information about using the command line to manage and
configure your IX20 device.
In this guide, task topicsshow how to perform tasks:
Web
Showshow to perform a task by using the local web interface.
Command line
Showshow to perform a task by using the command line interface.
Using Digi Remote Manager
By default, your IX20 device is configured to use Digi Remote Manager asits central management
server. Devices must be registered with Remote Manager using oneof the following options:
To Next Page
Loading...
Need help?
General