Services Configurea multicast route
IX20 User Guide
762
Log into the IX20 WebUI asa user with full Admin accessrights.
1. On the main menu, click Status.
2. Under Services, click NTP.
The NTPserver statuspage isdisplayed.
Command line
Show NTP information
1. Select the device in Remote Manager and click Actions> Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to accessthe Admin CLI.
2. Use the show ntp command at the system prompt:
> show ntp
NTP Status Status
-----------------
Status : Up
Sync Status : Up
Remote Refid ST T When Poll Reach Delay
Offset Jitter
---------------- ------------- -- - ---- ---- ----- ------ -----
- ------
*ec2-52-2-40-158 129.6.15.32 2 u 191 1024 377 33.570
+1.561 0.991
128.136.167.120 128.227.205.3 3 u 153 1024 1 43.583 -
1.895 0.382
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure a multicast route
Multicast routing allowsa device to transmit data to a single multicast address, which is then
distributed to a group of devicesthat are configured to be members of that group.
To configure a multicast route:
Web
1. Log into Digi Remote Manager, or log into the local Web UI asa user with full Admin access
rights.
2. Access the device configuration:
To Next Page
Loading...
Need help?
General