Services Location information
IX20 User Guide
703
Allowed values are any number of weeks, days, hours, minutes, or seconds, and take the
format number{w|d|h|m|s}.
For example, to set Location update interval to ten minutes, enter 10m or 600s.
6. For information about configuring Location sources, see the following:
a. For modem-based GNSS, see Enable or disable modem GNSS support.
b. To accept location information from an external location-enabled server, see Configure the
device to accept location messages from external sources.
c. To set a static location for the device, see Configure the device to use a user-defined static
location.
If multiple location sourcesare enabled at the same time, the device's location will be
determined based on the order that the location sources are listed here.
7. See Forward location information to a remote host for information about configuring
Destination servers.
8. See Configure geofencing for information about configuring Geofence.
9. Click Apply to savethe configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions> Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to accessthe Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable or disable the GNSSmodule:
n
To enable the module:
(config)> service location gnss true
(config)>
n
To disable the module:
(config)> service location gnss false
(config)>
4. Set the amount of time that the IX20 device will wait before polling location sources for
updated location data:
(config)> service location interval value
(config)>
where value is any number of hours, minutes, or seconds, and takes the format number
{h|m|s}.
For example, to set interval to ten minutes, enter either 10m or 600s:
To Next Page
Loading...
Need help?
General