Wi-Fi Configure theWi-Fi radio to support DFSchannelsin client mode
IX20 User Guide
317
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network >WiFi.
4. For Frequency band, select 5 GHz.
5. Click to enable DFSClient Support.
Note When DFS Client Support isenabled, any enabled access points that usethis radio will
not be started and cannot be used as accesspoints.
6. Click Apply to savethe configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions> Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to accessthe Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Set the channel for the radio:
a. Set the band for the radio to 5 GHz:
(config)> network wifi radio phy0 band 5000mhz
(config)>
To Next Page
Loading...
Need help?
General