Wi-Fi Configure theWi-Fi radio'schannel
IX20 User Guide
315
4. For Channel, select the channel. Only channelsappropriate for the band are displayed.
5. Click Apply to savethe configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions> Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to accessthe Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Set the channel for the radio:
a. Determine the band for the radio:
(config)> network wifi radio phy0 band
2400mhz
(config)>
b. Set the channel for the Wi-Fi radio:
(config)> network wifi radio phy0 2400mhz channel value
(config)>
where value is:
n
For 2.4 GHz:
l
1 through 11
l
auto
n
For 5 GHz:
l
36
l
40
l
44
l
48
l
auto