To Next Page

To Previous Page

System administration Schedulesystem maintenancetasks

IX20 User Guide

1037

If Duration window isset to one or more hours, the minutes field in Start time

isignored and the duration window will begin at the beginning of the specified

hour.

c. For Duration window, select the amount of time that the maintenance taskswill

be run. If Immediately is selected, all scheduled taskswill begin at the exact time

specified in Start time.

d. For Frequency, select whether the maintenance window will be started every day,

or once per week.

If Check if Python Out-of-Service is set, the maintenance window will only start if the

Python Out-of-Service is set. See Use Python to set the maintenance window for further

information.

7. If Central Management is disabled, click Device firmware update to instruct the system to

look for any updated device firmware during the maintenance window. If updated firmware is

found, it will then beinstalled. Thisoptionsis only available if Central Management is

disabled; see Central management for more information.

8. If Central Management is disabled, click to enable Modem firmware update to instruct the

system to look for any updated modem firmware during the maintenance window. If updated

firmware is found, it will then be installed. Modem firmware update looksfor updated firmware

both on the local device and over the network, using either a WANor cellular connection. This

optionsis only available if Central Management isdisabled; see Central management for

more information.

9. (Optional) Configure automated checking for device and modem firmware updates:

a. Click to expand Firmware update check.

b. Device firmware update check isenabled by default. This enables the automated

checking for device firmware updates.

c. Modem firmware update check isenabled by default. This enables the automated

checking for modem firmware updates.

d. For Frequency, select how often automated checking for device and modem firmware

should take place. Allowed values are Daily, Weekly, and Monthly. The default is Daily.

10. Click Apply to save the configuration and apply the change.

 Command line

1. Select the device in Remote Manager and click Actions> Open Console, or log into the IX20

local command line as a user with full Admin access rights.

Depending on your device configuration, you may be presented with an Access selection

menu. Type admin to accessthe Admin CLI.

2. At the command line, type config to enter configuration mode:

> config

(config)>

Digi IX20 User Manual

Questions and Answers: