To Next Page

To Previous Page

Monitoring intelliFlow

IX20 User Guide

1052

4. Click Enable intelliFlow.

5. For Zone, select the firewall zone. Internal clients that are being monitored by IntelliFlow

should bepresent on the specified zone.

6. Click Apply to savethe configuration and apply the change.

 Command line

1. Select the device in Remote Manager and click Actions> Open Console, or log into the IX20

local command line as a user with full Admin access rights.

Depending on your device configuration, you may be presented with an Access selection

menu. Type admin to accessthe Admin CLI.

2. At the command line, type config to enter configuration mode:

> config

(config)>

3. Enable IntelliFlow:

(config)> monitoring intelliflow enable true

4. Set the firewall zone. Internal clients that are being monitored by IntelliFlow should bepresent

on the specified zone:

a. Determine available zones:

(config)> monitoring intelliflow zone ?

Zone: The firewall zone which is assigned to the network interface(s)

that

intelliFlow will see as internal clients. intelliFlow relies on an

internal to

external relationship, where the internal clients are present on the

zone specified.

Format:

any

dynamic_routes

edge

external

hotspot

internal

ipsec

loopback

setup

Default value: internal

Current value: internal

Digi IX20 User Manual

Questions and Answers: