Interfaces WideArea Networks(WANs)
IX20 User Guide
110
l
Attempts: The number of attempts for this recovery action to perform, before
moving to the next recovery action.
l
Increase metric to change active default gateway: Increase the interface's
metric by this amount. This should be set to a number large enough to change
the routing table to use another default gateway. Thedefault is 100.
l
Override wait interval before performing the next recovery action: The
time to wait before the next test is run. If set to the default value of 0s, the Test
interval is used.
n
Restart interface.
If Restart interface isselected, complete the following:
l
Attempts: The number of attempts for this recovery action to perform, before
moving to the next recovery action.
l
Override wait interval before performing the next recovery action: The
time to wait before the next test is run. If set to the default value of 0s, the Test
interval is used.
n
Reset modem: This recovery action is available for WWAN interfaces only.
If Reset modem is selected, complete the following:
l
Attempts: The number of attempts for this recovery action to perform, before
moving to the next recovery action.
l
Override wait interval before performing the next recovery action: The
time to wait before the next test is run. If set to the default value of 0s, the Test
interval is used.
n
Switch to alternate SIM: Switches to an alternate SIM. Thisrecovery action is
available for WWAN interfaces only.
If Switch to alternate SIM is selected, complete the following:
l
Attempts: The number of attempts for this recovery action to perform, before
moving to the next recovery action.
l
Override wait interval before performing the next recovery action: The
time to wait before the next test is run. If set to the default value of 0s, the Test
interval is used.
n
Reboot device.
If Reboot device isselected, complete the following:
l
Attempts: The number of attempts for this recovery action to perform, before
moving to the next recovery action.
l
Override wait interval before performing the next recovery action: The
time to wait before the next test is run. If set to the default value of 0s, the Test
interval is used.
n
Execute custom Recovery commands.
If Recovery commandsis selected, complete the following:
l
Attempts: The number of attempts for this recovery action to perform, before
moving to the next recovery action.
l
The Commands to run to recovery connectivity.
To Next Page
Loading...