Digi IX20 - Page 1153

Command lineinterface Configuration mode
IX20 User Guide
1153
(config)> save
Configuration saved.
>
4. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Revert a subset of configuration changesto the default settings
There are two methodsto revert a subset of configuration changes to the default settings.
n
Enter the revert command with the path parameter. For example, to revert all changes to the
authentication methodsconfiguration:
1. Enter the revert command with the path set to auth method:
(config)> revert auth method
(config)>
2. Save the configuration and apply the change
(config)> save
Configuration saved.
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access
selection menu. Type quit to disconnect from the device.
n
Move to the location in the configuration and enter the revert command without the path
parameter. For example:
1. Change to the auth method node:
(config)> auth method
(config auth method)>
2. Enter the revert command:
(config auth method)> revert
(config auth method)>
3. Save the configuration and apply the change
(config auth method)> save
Configuration saved.
>
4. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access
selection menu. Type quit to disconnect from the device.