Interfaces WideArea Networks(WANs)
IX20 User Guide
116
o
up: The test will passonly if the referenced interface is up and passing its
own SureLink tests(if applicable).
o
down: The test will passonly if the referenced interface isdown or failing its
own SureLink tests(if applicable).
f. Repeat for each additional test.
6. Add recovery actions:
a. Type ... to return to the root of the configuration:
(config network interface my_wan surelink tests 1)> ...
(config)>
b. Add a recovery action:
(config)> add network interface my_wan surelink actions end
(config network interface my_wan surelink actions 0)>
c. New actionsare enabled by default. To disable:
(config network interface my_wan surelink actions 0)> enable false
(config network interface my_wan surelink actions 0)>
d. Create a label for the action:
(config network interface my_wan surelink actions 0)> label string
(config network interface my_wan surelink actions 0)>
e. Set the type of recovery action to reboot_device:
(config network interface my_wan surelink actions 0)> action reboot_
device
(config network interface my_wan surelink actions 0)>
n
Set the number of attemptsfor this recovery action to perform, before moving to
the next recovery action:
(config network interface my_wan surelink actions 0)> max_
attempts int
(config network interface my_wan surelink actions 0)>
The default is 3.
n
Set the time to wait before the next test is run. If set to the default value of 0s, the
test interval is used.
(config network interface my_wan surelink actions 0)> override_
interval int
(config network interface my_wan surelink actions 0)>
7. Optional SureLink configuration parameters:
To Next Page
Loading...
Need help?
General