Interfaces WideArea Networks(WANs)
IX20 User Guide
129
3. Configure active recovery on ETH1:
a. Click Network >Interface > ETH1 > SureLink.
b. For Test interval, type10s.
c. Click to expand Tests.
d. Disable the default DNStest:
i. Click to expand the default DNS configured test.
ii. Click to toggle off Enable.
e. Click to add a new test.
f. For Test type, select Ping test.
g. For Ping host, type43.66.93.111.
h. For Ping payload size, type256.
4. Repeat the above step for Modem to enable SureLink on that interface.
5. Click Apply to savethe configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions> Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to accessthe Admin CLI.
To Next Page
Loading...
Need help?
General