Interfaces WideArea Networks(WANs)
IX20 User Guide
166
n
IPv4 configuration:
l
The type being the way to control how the modem in the Digi device obtains an IPaddress
from the cellular network.
l
The metric for IPv4 routesassociated with the WAN.
l
The relative weight for IPv4 routes associated with the WAN.
l
The IPv4 management priority of the WAN. Theactiveinterface with the highest
management priority will have its addressreported as the preferred contact address for
central management and direct device access.
l
The IPv4 Maximum Transmission Unit (MTU) of the WAN.
l
When to use DNS: always, never, or only when this interfaceis the primary default route.
l
SureLink active recovery configuration. See Configure SureLink activerecovery to detect
WAN/WWAN failures for further information.
n
IPv6 configuration:
l
The type being the way to control how the modem in the Digi device obtains an IPaddress
from the cellular network.
l
The metric for IPv6 routesassociated with the WAN.
l
The relative weight for IPv6 routes associated with the WAN.
l
The IPv6 management priority of the WAN. Theactiveinterface with the highest
management priority will have its addressreported as the preferred contact address for
central management and direct device access.
l
The IPv6 Maximum Transmission Unit (MTU) of the WAN.
l
When to use DNS: always, never, or only when this interfaceis the primary default route.
l
SureLink active recovery configuration. See Configure SureLink activerecovery to detect
WAN/WWAN failures for further information.
Web
1. Log into Digi Remote Manager, or log into the local Web UI asa user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
To Next Page
Loading...
Need help?
General