Interfaces Local Area Networks(LANs)
IX20 User Guide
186
a. Click to expand MAC address allowlist.
b. For Add MAC address, click .
c. Typethe MACaddress.
14. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions> Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to accessthe Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new LANor edit an existing one:
n
To create a new LAN named my_lan:
(config)> add network interface my_lan
(config network interface my_lan)>
n
To edit an existing LAN named my_lan, change to the my_lan node in the configuration
schema:
(config)> network interface my_lan
(config network interface my_lan)>
4. Set the appropriate firewall zone:
(config network interface my_lan)> zone zone
(config network interface my_lan)>
See Firewall configuration for further information.
5. Select an Ethernet device, a Wi-Fi device, or a bridge. See Bridging for more information about
bridging.
a. Enter device ?to view available devicesand the proper syntax.
(config network interface my_lan)> device ?
Device: The network device used by this network interface.
Format:
/network/device/eth1
/network/device/eth2
/network/device/loopback
/network/bridge/hotspot_bridge
/network/bridge/lan
/network/wireless/ap/digi_ap
/network/wireless/ap/digi_hotspot_ap
Current value:
To Next Page
Loading...
Need help?
General