Digi IX20

Serial port Configure Remote Accessmode
IX20 User Guide
264
(config)> add serial port1 service tcp acl interface end
value
(config)>
Where value is an interface defined on your device.
Display a list of available interfaces:
Use ... network interface ?to display interface information:
(config)> ... network interface ?
Interfaces
Additional Configuration
-------------------------------------------
defaultip Default IP
defaultlinklocal Default Link-local IP
eth1 ETH1
eth2 ETH2
loopback Loopback
modem Modem
(config)>
Repeat thisstep to list additional interfaces.
n
To limit access based on firewall zones:
(config)> add serial port1 service tcp acl zone end value
(config)>
Where value is a firewall zone defined on your device, or the any keyword.
Display a list of available firewall zones:
Type ... firewall zone ?at the config prompt:
(config)> ... firewall zone ?
Zones: A list of groups of network interfaces that
can be referred to by packet
filtering rules and access control lists.
Additional Configuration
-------------------------------------------------
------------------------------
any
dynamic_routes
edge
external
hotspot
internal