Serial port ConfigureUDPserial mode
IX20 User Guide
279
b. (Optional) For Socket String ID, enter a string that should beadded at the beginning of
each packet.
c. For Destinations, you can configure the remote sites to which you want to send data. If
you do not specify any destinations, the IX20 sends new data from the last IPaddress and
port from which data wasreceived. To add a destination:
i. Click Add Destination. Adestination row is added.
ii. (Optional) For Description, enter a description of the destination.
iii. For Hostname, enter the host name or IPaddress of the remote site to which data
should besent.
iv. For Port, enter the port number of the remote site to which data should be sent.
You can also configure access control for the serial port.
To do this, you need to go to Device Configuration:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
b. Access the configuration for the appropriate type of service:
i. Click to expand Serial.
ii. Click to expand the appropriate serial port.
iii. Click to expand UDP serial.
iv. Click to expand Access Control List.
To Next Page
Loading...
Need help?
General