Digi IX20 User Manual

Wi-Fi ConfiguretheWi-Fi radio'stransmit power
IX20 User Guide
321
3. Click Network >WiFi.
4. For Tx power percentage, typeor select the appropriate percentage for the Wi-Fi radio's
transmit power.
5. Click Apply to savethe configuration and apply the change.
 Command line
1. Select the device in Remote Manager and click Actions> Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to accessthe Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Set the transmit power percentage for the radio:
(config)> network wifi radio phy0 tx_power value
(config)>
where value is any integer between 1 and 100 and represents the percentage of transmit power
that the Wi-Fi module should use.
4. Save the configuration and apply the change
(config)> save
Configuration saved.
>

Digi IX20 Specifications

General

Category	Wireless Router
Cellular Connectivity	4G LTE
Ethernet Ports	4
Wi-Fi	802.11ac
SIM Slots	2
WAN Ports	1
LAN Ports	3
Weight	0.5 kg
Operating Temperature	-40°C to +70°C (-40°F to +158°F)