Routing Virtual Router Redundancy Protocol (VRRP)
IX20 User Guide
462
instance.
e. For backup devices, enable and configure SureLink on the VRRPinterface. Generally, this
should bea LAN interface; VRRP+will then monitor the LAN using SureLink to determine if
the interface has network connectivity and promote a backup to master if SureLink fails.
i. Click to expand IPv4 > SureLink.
ii. Click Enable.
iii. For Interval, typea the amount of time to wait between connectivity tests. To
guarantee seamlessinternet access for VRRP+purposes, SureLink testsshould occur
more often than the default of 15 minutes.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and take
the format number{w|d|h|m|s}. For example, to set Interval to five seconds, enter 5s.
iv. Click to expand Test targets>Test target.
v. Configure the test target. For example, to configure SureLink to verify internet
connectivity on the LAN by pinging https://remotemanager.digi.com:
i. For Test Type, select Ping test.
ii. For Ping host, type https://remotemanager.digi.com.
11. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions> Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to accessthe Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
To Next Page
Loading...
Need help?
General