Digi IX20 - Page 490

Virtual PrivateNetworks(VPN) IPsec
IX20 User Guide
490
b. Click to expand Local traffic selector.
c. For Type, select one of the following:
n
Address: The addressof a local network interface.
For Address, select the appropriate interface.
n
Network: Thesubnet of a local network interface.
For Address, select the appropriate interface.
n
Custom network: Auser-defined network.
For Custom network, enter the IPv4 addressand optional netmask.
n
Request a network: Requestsa network from the remote peer.
n
Dynamic: Uses the address of the local endpoint.
d. For Protocol, select one of the following:
n
Any: Matches any protocol.
n
TCP: Matches TCPprotocol only.
n
UDP: Matches UDPprotocol only.
n
ICMP: Matches ICMPrequests only.
n
Other protocol: Matchesan unlisted protocol.
If Other protocol is selected, type the number of the protocol.
e. For Port, type the port matching criteria.
Allowed values are a port number, a range of port numbers, or any.
f. (Optional) Click to expand Remote traffic selector.
g. For Remote network, enter the IPaddressand optional netmask of the remote network.
h. For Protocol, select one of the following:
n
Any: Matches any protocol.
n
TCP: Matches TCPprotocol only.
n
UDP: Matches UDPprotocol only.
n
ICMP: Matches ICMPrequests only.
n
Other protocol: Matchesan unlisted protocol.
If Other protocol is selected, type the number of the protocol.