Virtual PrivateNetworks(VPN) IPsec
IX20 User Guide
519
l
Override wait interval before performing the next recovery action: The
time to wait before the next test is run. If set to the default value of 0s, the Test
interval is used.
f. Repeat for each additional recovery action.
13. (Optional) Configure advanced SureLink parameters:
a. Click to expand Advanced settings.
b. For Delayed Start, type the amount of time to wait while the device isstarting before
SureLink testing begins. This setting is bypassed when the interface is determined to be
up.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and take the
format number{w|d|h|m|s}.
For example, to set Delayed start to ten minutes, enter 10m or 600s.
The default is 300 seconds.
c. For Backoff interval, typethe time to add to the test interval when restarting the list of
actions. This option is capped at 15 minutes.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and take the
format number{w|d|h|m|s}.
For example, to set Backoff interval to ten minutes, enter 10m or 600s.
The default is 300 seconds.
d. Test interface gateway by pingingis used by the Interface gateway Ping test as the
endpoint for traceroute to use to determine the interface gateway. The default is 8.8.8.8,
and should only be changed if this IPaddressis not accessible due to networking issues.
14. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions> Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to accessthe Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new IPsec tunnel, or edit an existing one:
n
To create a new IPsec tunnel, see Configure an IPsec tunnel.
n
To edit an existing IPsec tunnel, change to the IPsec tunnel's node in the configuration
schema. For example, for an IPsec tunnel named ipsec_example, change to the ipsec_
example node in the configuration schema:
(config)> vpn ipsec tunnel ipsec_example
(config vpn ipsec tunnel ipsec_example)>
To Next Page
Loading...
Need help?
General