Digi IX20 - Page 566

Virtual PrivateNetworks(VPN) OpenVPN
IX20 User Guide
566
(config vpn openvpn client name)> use_file false
(config vpn openvpn client name)>
5. Set the mode used by the OpenVPNserver:
(config vpn openvpn client name)> device_type value
(config vpn openvpn client name)>
where value is either tun or tap. The default is tun.
6. Set the firewall zone for the OpenVPNclient:
(config vpn openvpn client name)> zone value
(config vpn openvpn client name)>
To view a list of available zones:
(config vpn openvpn client name)> zone ?
Zone: The zone for the openvpn client interface.
Format:
any
dynamic_routes
edge
external
hotspot
internal
ipsec
loopback
setup
Current value:
(config vpn openvpn client name)>
7. (Optional) Set the route metric for the OpenVPNserver. If multiple active routes match a
destination, the route with the lowest metric will be used.
(config vpn openvpn client name)> metric value
(config vpn openvpn client name)>
where value is an interger between 0 and 65535. The default is 0.
8. (Optional) Set the login credentials asconfigured on the OpenVPNserver:
(config vpn openvpn client name)> username value
(config vpn openvpn client name)> password value
(config vpn openvpn client name)>
9. Set the IPaddress of the OpenVPNserver:
(config vpn openvpn client name)> server ip_address
(config vpn openvpn client name)>