Virtual PrivateNetworks(VPN) L2TPv3 Ethernet
IX20 User Guide
629
3. Click VPN >L2TPv3 ethernet.
4. For Add L2TPv3 ethernet tunnel, type a name for the tunnel and click .
5. For Remote endpoint, type the IPv4 addressof the remote endpoint.
6. For Local endpoint, select the interface that will be the local endpoint.
7. For Tunnel ID, type the tunnel identifier for thistunnel. This must match the value for Peer
tunnel ID on the remote peer. Allowed value is any integer between 1 and 4294967295.
8. For Peer tunnel ID, typethe Tunnel ID of the remote peer.
9. (Optional) For Encapsulation type, select either UDP or IP. If UDP is selected:
a. For UDP source port, typethe number of the source UDP port to be used for the tunnel.
b. For UDP destination port, type the number of the destination UDP port to be used for the
tunnel.
c. (Optional) Click to enable UDP checksum to calculate and check the UDPchecksum.
10. Click to expand Sessions.
a. For Add Sesssion, type a name for a session carried by the parent tunnel and click .
b. For Session ID, type the session identifier for this session. This must match the value for
Peer session ID on the remote peer. Allowed value is any integer between 1 and
4294967295.
c. For Peer session ID, typethe Session ID of the remote peer.
d. (Optional) For Cookie, type the cookie value to be assigned to the session. Allowed value
is8 or 16 hex digits.
e. (Optional) For Peer cookie, type the Cookie value of the remote peer.
f. For Layer2SpecificHeader type, select the Layer2Specific header type. This must match
what is configured on the remote peer.
g. For Sequence numbering control, determine the sequence number control to prevent or
detect out of order packets. Allowed values are:
n
None: No sequence numbering.
n
Send: Add asequence number to each outgoing packet.
n
Receive: Reorder packets if they are received out of order.
n
Both: Add a sequence number to each outgoing packet, and reorder packets if they
are received out of order.
The default is None.
h. Repeat for additional sessions.
11. Click Apply to save the configuration and apply the change.
Command line
To Next Page
Loading...
Need help?
General