Digi IX20 - Page 650

Services Configurethe web administration service
IX20 User Guide
650
Enable or disable the web administration service
The web administration service isenabled by default. To disable the service, or enable it if it hasbeen
disabled:
 Web
1. Log into Digi Remote Manager, or log into the local Web UI asa user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Services> Web administration.
4. Click Enable.
5. Click Apply to savethe configuration and apply the change.
 Command line
1. Select the device in Remote Manager and click Actions> Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to accessthe Admin CLI.