Services Configure SSH access
IX20 User Guide
661
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in Use Digi Remote Manager to view and manage your
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Services> SSH.
4. (Optional) For Port, enter the port number for the service. Normally thisshould not be
changed.
5. Click Access control list to configure accesscontrol:
n
To limit access to specified IPv4 addresses and networks:
a. Click IPv4 Addresses.
b. For Add Address, click .
c. For Address, enter the IPv4 addressor network that can accessthe device's SSH
service. Allowed values are:
l
Asingle IPaddress or host name.
l
Anetwork designation in CIDRnotation, for example, 192.168.1.0/24.
l
any: No limit to IPv4 addresses that can access the SSH service.
d. Click again to list additional IPaddresses or networks.
n
To limit access to specified IPv6 addresses and networks:
a. Click IPv6 Addresses.
b. For Add Address, click .
c. For Address, enter the IPv6 addressor network that can accessthe device's SSH
service. Allowed values are:
To Next Page
Loading...
Need help?
General