To Next Page

To Previous Page

Services WAN bonding

IX20 User Guide

690

4. Set the hostname or IPv4 address of the external server hosting the WAN bonding service:

(config)> network sdwan wan_bonding hostname hostname-or-IPv4-address

(config)>

5. (Optional) Set the port number that the external server usesfor the WAN bonding connection:

(config)> network sdwan wan_bonding host_port port

(config)>

Allowed values are any port number, or the keyword any. The default is 443.

6. Set the username and password to authenticate with the WAN bonding service:

(config)> network sdwan wan_bonding username username

(config)> network sdwan wan_bonding password password

(config)>

7. Set the firewall zone for this interface. To treat the interfaceasa normal WAN interface, this

would be left at the default of external.

a. Use the ?to determine available zones:

(config)> network sdwan wan_bonding zone ?

Zone: The zone for the new bonded interface. To treat the interface as

a typical

WAN interface, this should be set to External.

Format:

any

dynamic_routes

edge

external

hotspot

internal

ipsec

loopback

setup

Default value: external

Current value: external

(config)>

b. Set the zone:

(config)> network sdwan wan_bonding zone zone

(config)>

8. Configure the device's WAN interfaces that will be bonded:

a. Add the first interface:

(config)> add network sdwan wan_bonding interfaces end

(config network sdwan wan_bonding interfaces 0)>

Digi IX20 User Manual

Questions and Answers: