Digi IX20 - Page 698

Services Simple Network Management Protocol (SNMP)
IX20 User Guide
698
eth1 ETH1
eth2 ETH2
loopback Loopback
modem Modem
(config)>
Repeat thisstep to list additional interfaces.
n
To limit access based on firewall zones:
(config)> add service snmp acl zone end value
(config)>
Where value is a firewall zone defined on your device, or the any keyword.
Display a list of available firewall zones:
Type ... firewall zone ?at the config prompt:
(config)> ... firewall zone ?
Zones: A list of groups of network interfaces that can be
referred to by packet
filtering rules and access control lists.
Additional Configuration
--------------------------------------------------------
-----------------------
any
dynamic_routes
edge
external
hotspot
internal
ipsec
loopback
setup
(config)>
Repeat thisstep to include additional firewall zones.
5. Set the name of the user that will be used to connect to the SNMPagent.
(config)> service snmp username name
(config)>
6. Set the password for the user that will be used to connect to the SNMPagent:
(config)> service snmp password pwd
(config)>
7. (Optional) Set the port number for the SNMPagent. The default is161.