Central management Configureyour device for Digi Remote Manager support
IX20 User Guide
71
d. Click to expand Config.
Local Web UI:
a. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Monitoring>Device Health.
4. (Optional) Click to expand Data point tuning.
Data point tuning optionsallow to you configure what data are uploaded to the Digi Remote
Manager. All optionsare enabled by default.
5. Only report changed values to Digi Remote Manager is enabled by default.
When enabled:
n
The device only reports device health metrics that havechanged health metrics were
last uploaded. This is useful to reduce the bandwidth used to report health metrics.
n
All metrics are uploaded once every hour.
When disabled, all metricsare uploaded every Health sample interval.
6. Device health data upload is enabled by default. To disable, toggle off Enable Device Health
samplesupload.
7. For Health sample interval, select the interval between health sample uploads.
8. Click Apply to savethe configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions> Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to accessthe Admin CLI.
To Next Page
Loading...
Need help?
General