Services Modbusgateway
IX20 User Guide
745
n
If connection_type is set to serial:
i. Set the serial port:
i. Use the ?to determine available serial ports:
(config service modbus_gateway client test_modbus_
client)> ... serial port ?
Serial
Additional Configuration
-------------------------------------------------------
------------------------
port1 Port 1
(config service modbus_gateway client test_modbus_
client)>
ii. Set the port:
(config service modbus_gateway client test_modbus_
client)> serial port
(config service modbus_gateway client test_modbus_
client)>
ii. Set the packet mode:
(config service modbus_gateway client test_modbus_client)>
serial packet_mode value
(config service modbus_gateway client test_modbus_client)>
where value is either rtu or ascii. The default is rtu.
iii. Set the maximum allowable time between bytes in a packet:
(config service modbus_gateway client test_modbus_client)>
serial idle_gap value
(config service modbus_gateway client test_modbus_client)>
where value is any number between 10 millisecondsand one second, and take
the format number{ms|s}.
For example, to set idle_gap to one second, enter 1000msor 1s.
iv. (Optional) Enable half-duplex (two wire) mode:
(config service modbus_gateway client test_modbus_client)>
serial half_duplex true
(config service modbus_gateway client test_modbus_client)>
d. (Optional) Enable the gateway to send broadcast messages to thisclient:
To Next Page
Loading...
Need help?
General