Services Usethe MQTT broker service
IX20 User Guide
781
n
The topic.
n
The signal level wildcard, +.
n
The multi-level wildcard, #.
iii. Set the accesstypeto apply to the topic:
(config service mqtt client 0 topic_acl 0)> access value
(config service mqtt client 0 topic_acl 0)>
where value is one of:
n
deny
n
read
n
readwrite
n
write
The default is readwrite.
iv. Add additional topics:
(config service mqtt client 0 topic_acl 0)> add .. .. topic_acl
end
(config service mqtt client 0 topic_acl 1)>
v. Repeat the above steps to set the topic and accesstype.
11. Set the encryption:
a. Return to the root of the configuration:
(config service mqtt client 0 topic_acl 1)> ...
(config)>
b. Set the encryption type:
(config)> service mqtt encryption type value
(config)>
where value is either:
n
none
n
psk
If psk isused:
a. (Optional) Set a string that identifiesthe listener and is sent to the clients:
(config)> service mqtt encryption identifier string
(config)>
b. Enable the PSK identity sent by the client to be used as its username:
(config)> service mqtt encryption use_identity_as_username true
(config)>
To Next Page
Loading...
Need help?
General