Interfaces WideArea Networks(WANs)
IX20 User Guide
86
5. Click Apply to savethe configuration and apply the change.
The IX20 device is now configured to use the cellular modem WWAN, Modem, asits highest priority
WAN, and its Ethernet WAN, ETH1, as itssecondary WAN.
Command line
1. Select the device in Remote Manager and click Actions> Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to accessthe Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Set the metricsfor Modem:
a. Set the IPv4 metric for Modem to 1. For example:
(config)> network interface modem ipv4 metric 1
(config)>
b. Set the IPv6 metric for Modem to 1:
(config)> network interface modem ipv6 metric 1
(config)>
4. Set the metricsfor ETH1:
a. Set the IPv4 metric for ETH1 to 2:
(config)> network interface eth1 ipv4 metric 2
(config)>
b. Set the IPv6 metric for ETH1 to 1:
To Next Page
Loading...