User authentication Example user configuration
IX20 User Guide
922
4. In Add User: enter a name for the user and click .
The user configuration window isdisplayed.
5. Enter a Password for the user.
6. Assign the user to the admin group:
a. Click Groups.
b. For Add Group, click .
c. For Group, select the admin group.
d. Verify that the admin group hasfull administrator rights:
i. Click Authentication > Groups.
ii. Click admin.
iii. Verify that the admin group hasAdmin accessenabled. If not, click Admin accessto
enable.
iv. Verify that Access level is set to Full access. If not, select Full access.
e. Verify that Local usersis one of the configured authentication methods:
i. Click Authentication > Methods.
ii. Verify that Local usersis one of the methodslisted in the list. If not:
i. For Add Method, click .
ii. For Method, select Local users.
7. Click Apply to savethe configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions> Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to accessthe Admin CLI.
To Next Page
Loading...
Need help?
General