Digi IX20 - Page 927

User authentication Example user configuration
IX20 User Guide
927
6. Create the local user:
a. Click Authentication > Users.
b. In Add User:, type admin1 and click .
c. For password, typepassword1.
d. Assign the user to the admin group:
i. Click Groups.
ii. For Add Group, click .
iii. For Group, select the admin group.
a. Verify that the admin group has full administrator rights:
i. Click Authentication > Groups.
ii. Click admin.
iii. Verify that the admin group hasAdmin accessenabled. If not, click Admin accessto
enable.
iv. Verify that Access level is set to Full access. If not, select Full access.
7. Click Apply to savethe configuration and apply the change.
 Command line
1. Configure a user on the RADIUS server:
a. On the ubuntu machine hosting the FreeRadiusserver, open the /etc/freeradius/3.0/users
file:
$ sudo gedit /etc/freeradius/3.0/users
b. Add a RADIUS user to the usersfile:
admin1 Cleartext-Password := "password1"
Unix-FTP-Group-Names := "admin"