Digi IX20

Interfaces WideArea Networks(WANs)
IX20 User Guide
93
o
Down: The test will pass only if the referenced interface is down or failing its
own SureLink tests(if applicable).
e. Repeat for each additional test.
11. Add recovery actions:
a. Click to expand Recovery actions.
By default, there are two preconfigured recovery actions:
n
Update routing: Uses the Change default gateway action, which increasesthe
interface's metric by 100 to change the default gateway.
n
Restart interface.
b. Click .
New recovery actionsare enabled by default. To disable, click to toggle off Enable.
c. Typea Label for the recovery action.
d. For Recovery type, select Reboot device.
e. For Recovery type, select the type of recovery action. If multiple recovery actionsare
configured, they are performed in the order that they are listed.
n
Change default gateway: Increases the interface's metric to change the default
gateway.
If Change default gateway is selected, complete the following:
l
Attempts: The number of attempts for this recovery action to perform, before
moving to the next recovery action.
l
Increase metric to change active default gateway: Increase the interface's
metric by this amount. This should be set to a number large enough to change
the routing table to use another default gateway. Thedefault is 100.
l
Override wait interval before performing the next recovery action: The
time to wait before the next test is run. If set to the default value of 0s, the Test
interval is used.
n
Restart interface.
If Restart interface isselected, complete the following:
l
Attempts: The number of attempts for this recovery action to perform, before
moving to the next recovery action.
l
Override wait interval before performing the next recovery action: The
time to wait before the next test is run. If set to the default value of 0s, the Test
interval is used.
n
Reset modem: This recovery action is available for WWAN interfaces only.
If Reset modem is selected, complete the following:
l
Attempts: The number of attempts for this recovery action to perform, before
moving to the next recovery action.