Firewall Configurecaptive portals
IX20 User Guide
958
13. Click Apply to save the configuration and apply the change.
Command line
1. Select the device in Remote Manager and click Actions> Open Console, or log into the IX20
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to accessthe Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. To create an active portal called portal1:
(config)> add firewall portal portal1
(config firewall portal portal1)>
Captive portals are enabled by default. To disable the portal:
(config firewall portal portal1)> enable false
(config firewall portal portal1)>
4. Set the network interface for the portal. Traffic received on this interface'snetwork device will
not be forwarded unless the client has been granted access.
a. Use the ?to determine available interfaces:
(config firewal portal portal1)> interface ?
Interface: The network interface to run the portal on. Traffic
received on this interface's network device will not be forwarded
unless the client has been granted access.
Format:
/network/interface/defaultip
/network/interface/defaultlinklocal
/network/interface/eth1
/network/interface/eth2
/network/interface/loopback
Current value:
(config firewal portal portal1)> interface
b. Set the interface. For example:
(config firewal portal portal1)> interface /network/interface/eth1
(config firewal portal portal1)>
5. Set the amount of time that a user session remainsvalid. After the session timesout, the user
will be required to log in again.
To Next Page
Loading...
Need help?
General