Digi IX20 - Page 971

Firewall ConfigureQuality of Serviceoptions
IX20 User Guide
971
(config network qos 2 policy 0 rule 0)> src address value
(config network qos 2 policy 0 rule 0)>
where value usesthe format IPv4_address[/netmask], or any to match any
IPv4 address.
n
address6: Only traffic from the IPaddresstyped in IPv6 addresswill be
matched. Set the address that will be matched:
(config network qos 2 policy 0 rule 0)> src address6 value
(config network qos 2 policy 0 rule 0)>
where value usesthe format IPv6_address[/prefix_length], or any to match
any IPv6 address.
n
mac: Only traffic from the MAC addresstyped in MAC addresswill be matched.
Set the MACaddressto be matched:
(config network qos 2 policy 0 rule 0)> src mac MAC_address
(config network qos 2 policy 0 rule 0)>
ix. Set the destination addresstype:
(config network qos 2 policy 0 rule 0)> dst type value
(config network qos 2 policy 0 rule 0)>
where value is one of:
n
any: Traffic destined for anywhere will be matched.
See Firewall configuration for more information about firewall zones.
n
interface: Only traffic destined for the selected Interface will be matched. Set
the interface:
i. Use the ?to determine available interfaces:
(config network qos 2 policy 0 rule 0)> dst interface ?
Interface: Match the IP address with the specified
interface's network address.
Format:
/network/interface/defaultip
/network/interface/defaultlinklocal
/network/interface/eth1
/network/interface/eth2
/network/interface/loopback
Current value:
(config network qos 2 policy 0 rule 0)> dst interface
ii. Set the interface. For example: