To Next Page

To Previous Page

Firewall Web filtering

IX20 User Guide

977

8. For IP address, enter the IPaddress of the DNSserver.

9. (Optional) Repeat for additional DNSservers.

10. Click Apply to save the configuration and apply the change.

 Command line

1. Select the device in Remote Manager and click Actions> Open Console, or log into the IX20

local command line as a user with full Admin access rights.

Depending on your device configuration, you may be presented with an Access selection

menu. Type admin to accessthe Admin CLI.

2. At the command line, type config to enter configuration mode:

> config

(config)>

3. Enable web filtering:

(config)> firewall web-filter enable true

(config)>

4. Set the web filter service typeto manual:

(config)> firewall web-filter service manual

(config)>

5. Add a DNSserver:

(config)> add firewall web-filter server end

(config firewall web-filter server 0)>

6. Set the DNSserver's IPaddress:

(config firewall web-filter server 0)> ip ip_address

(config firewall web-filter server 0)>

7. (Optional) Repeat for additional DNSservers.

For example, to configure manual web-filtering using Cisco's open DNSservers:

a. Enable web filtering:

(config)> firewall web-filter enable true

(config)>

Digi IX20 User Manual

Questions and Answers: