Enterasys D2 D2G124-12P

show port broadcast
D-Series CLI Reference 4-29
show port broadcast
Usethiscommandtodisplayportbroadcastsuppressionthresholds.
Syntax
show port broadcast [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,broadcaststatusofallportswillbedisplayed.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplaythebroadcastsuppressionthresholdsforports1through4:
D2(su)->show port broadcast ge.1.1-4
Port Total BC Threshold
Packets (pkts/s)
----------------------------------------
ge.1.1 0 50
ge.1.2 0 50
ge.1.3 0 40
ge.1.4 0 14881
set port broadcast
Usethiscommandtosetthebroadcastsuppressionthreshold,inpacketspersecond,ononeor
moreports.Thissetsathresholdonthebroadcasttrafficthatisreceivedandswitchedouttoother
ports.
Syntax
set port broadcast port-string threshold-val
Parameters
port‐string (Optional)Selecttheportsforwhichtoshowbroadcastsuppression
thresholds.Foradetaileddescriptionofpossibleport‐stringvalues,refer
to“PortStringSyntaxUsedintheCLI”onpage4‐1.
port‐string Selecttheportsforwhichtoconfigurebroadcastsuppressionthresholds.
Foradetaileddescriptionofpossibleport‐stringvalues,referto“Port
StringSyntaxUsedintheCLI”onpage4‐1.
threshold‐val Setsthepacketspersecondthresholdonbroadcasttraffic.Maximum
valueis
• 148810forFast
Ethernetports
• 1488100for1‐Gigabitports.
• 14881000for10‐Gigabitports