Enterasys D2 D2G124-12P

clear multiauth mode
15-32 Security Configuration
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
MultiauthmultimoderequiresthatMAC,PWA,and802.1Xauthenticationbeenabledglobally,
andconfiguredappropriatelyonthedesiredportsaccordingtotheircorrespondingcommand
setsdescribedinthischapter.Referto“Configuring802.1XAuthentication”onpage 15‐9and
“ConfiguringMACAuthentication”onpage 15‐19and“ConfiguringPortWeb
Authentication
(PWA)”onpage 15‐57.
Example
Thisexampleshowshowtoenablesimultaneousmultipleauthentications:
D2(rw)->set multiauth mode multi
clear multiauth mode
Usethiscommandtoclearthesystemauthenticationmode.
Syntax
clear multiauth mode
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoclearthesystemauthenticationmode:
D2(rw)->clear multiauth mode
multi Allowsthesystemtousemultipleauthenticatorssimultaneously(802.1x,
PWA,andMACAuthentication)onaport. Thisisthedefaultmode.
strict Usermustauthenticateusing802.1xauthentica tionbeforenormaltraffic
(anythingotherthanauthenticationtraffic)canbeforwarded.