Enterasys D2 D2G124-12P

clear dhcp pool bootfile
D-Series CLI Reference 14-19
Mode
Switchcommand,read‐write.
Example
Thisexamplesetsthebootimagefilenameforaddresspoolnamed“auto1.”
D2(rw)->set dhcp pool auto1 bootfile image1.img
clear dhcp pool bootfile
Usethiscommandtoremoveadefaultbootimagefromtheaddresspoolbeingconfigured.
Syntax
clear dhcp pool poolname bootfile
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleremovesthebootimagefilenamefromaddresspoolnamed“auto1.”
D2(rw)->clear dhcp pool auto1 bootfile
set dhcp pool next-server
Usethiscommandtospecifythefileserverfromwhichthedefaultbootimageistobeloadedby
theclient.
Syntax
set dhcp pool poolname next-server ip-address
Parameters
Defaults
None.
poolname Specifiesthenameoftheaddresspool.Poolnamesmaybeupto31
charactersinlength.
poolname Specifiesthenameoftheaddresspool.Poolnamesmaybeupto31
charactersinlength.
ip‐address SpecifiestheIPaddressofthefileservertheDHCPclientshouldcontact
toloadthedefaultbootimage.