Enterasys D2 D2G124-12P

set dhcp pool
14-12 DHCP Server Configuration
set dhcp pool
UsethiscommandtocreateandassignanametoaDHCPserverpoolofaddresses.Upto16
addresspoolsmaybeconfiguredonaD‐Series.Notethatenteringthiscommandisnotrequired
tocreateanaddresspoolbeforeconfiguringotheraddresspoolparameters.
Syntax
set dhcp pool poolname
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexamplecreatesanaddresspoolnamed“auto1.”
D2(rw)->set dhcp pool auto1
clear dhcp pool
UsethiscommandtodeleteaDHCPserverpoolofaddresses.
Syntax
clear dhcp pool poolname
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampledeletestheaddresspoolnamed“auto1.”
D2(rw)->clear dhcp pool auto1
poolname Specifiesthenameoftheaddresspool.Poolnamesmaybeupto31
charactersinlength.
poolname Specifiesthenameoftheaddresspool.Poolnamesmaybeupto31
charactersinlength.