Enterasys D2 D2G124-12P

clear rmon capture
13-22 RMON Configuration
Defaults
Ifnotspecified,actiondefaultstolock.
Ifnotspecified,offsetdefaultsto0.
Ifnotspecified,asksizedefaultsto‐1(whichwillrequestasmanyoctetsaspossible).
Ifsliceisnotspecified,1 518willbeapplied.
Ifloadsizeisnotspecified,100willbeapplied.
Ifownerisnotspecified,
itwillbesettomonitor.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtocreateRMON captureentry1to“listen”onchannel62 8:
D2(rw)->set rmon capture 1 628
clear rmon capture
UsethiscommandtoclearsanRMONcaptureentry.
Syntax
clear rmon capture index
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Example
ThisexampleshowshowtoclearRMONcaptureentry 1:
D2(rw)->clear rmon capture 1
index Specifiesthecaptureentrytobecleared.