Enterasys D2 D2G124-12P - Commands; Set Webview; Show Webview

show webview
2-52 Basic Configuration
Commands
show webview
UsethiscommandtodisplayWebViewstatus.
Syntax
show webview
Parameters
None.
Defaults
None.
Mode
Switchcommand,read‐only.
Example
ThisexampleshowshowtodisplayWebViewstatus:
D2(rw)->show webview
WebView is Enabled.
set webview
UsethiscommandtoenableordisableWebViewontheswi tch.
Syntax
set webview {enable | disable}
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
For information about... Refer to page...
show webview 2-52
set webview 2-52
show ssl 2-53
set ssl 2-53
enable|disable EnableordisableWebViewontheswitch.