Enterasys D2 D2G124-12P

show port ingress filter
D-Series CLI Reference 7-9
Defaults
None.
Mode
Switchcommand,read‐write.
Example
Thisexampleshowshowtoresetportsge.1.3through11toaVLAN IDof1(HostVLAN):
D2(su)->clear port vlan ge.1.3-11
show port ingress filter
Usethiscommandtoshowallportsthatareenabledforportingressfiltering,whichlimits
incomingVLANIDframesaccordingtoaportVLANegresslist.IftheVLANIDspecifiedinthe
receivedframeisnotontheport’sVLANegresslist,thenthatframeisdroppedandnot

forwarded.
Syntax
show port ingress-filter [port-string]
Parameters
Defaults
Ifport‐stringisnotspecified,ingressfilteringstatusforallportswillbedisplayed.
Mode
Switchcommand,read‐only.
Example
Thisexampleshowshowtodisplaytheportingressfilterstatusforports10through15inslot1.
Inthiscase,theportsare disabledforingressfiltering:
D2(su)->show port ingress-filter ge.1.10-15
Port State
-------- ---------
ge.1.10 disabled
ge.1.11 disabled
ge.1.12 disabled
ge.1.13 disabled
ge.1.14 disabled
ge.1.15 disabled
port‐string (Optional)Specifiestheport(s)forwhichtodisplayingressfilteringstatus.
Foradetaileddescriptionofpossibleport‐stringvalues,referto“PortString
SyntaxUsedintheCLI”onpage 4‐1.