To Next Page

To Previous Page

set vlan dynamicegress

7-16 802.1Q VLAN Configuration

Example

ThisexampleshowshowtodisplaythedynamicegressstatusforVLANs50‐55:

D2(rw)->show vlan dynamicegress 50-55

VLAN 50 is disabled

VLAN 51 is disabled

VLAN 52 is disabled

VLAN 53 is enabled

VLAN 54 is enabled

VLAN 55 is enabled

set vlan dynamicegress

UsethiscommandtoadministrativelysetthedynamicegressstatusforoneormoreVLANs.

Syntax

set vlan dynamicegress vlan-list {enable | disable}

Parameters

Defaults

None.

Mode

Switchcommand,read‐write.

Usage

IfdynamicegressisenabledforaparticularVLAN,whenaportreceivesaframetaggedwiththat

VLAN’sID,theswitchwilladdthereceivingporttothatVLAN’segresslist.Dynamicegressis

disabledontheD‐Seriesbydefault.

Forexample,assumeyouhave20AppleTalkuserson

yournetworkwhoare mobileusers(thatis,

usedifferentportseveryday),butyouwanttokeeptheAppleTalktrafficisolatedinitsown

VLAN.YoucancreateanAppleTalkVLANwithaVLANID of55withaclassificationrulethatall

AppleTalktrafficgetstaggedwithVLANID

55.Then,youenabledynamicegressforVLAN55.

Now,whenanAppleTalkuserplugsintoport

ge.3.5andsendsanAppleTalkpacket,theswi tch

willtagthepackettoVLAN55andalsoaddport

ge.3.5toVLAN55’segresslist,whichallowsthe

AppleTalkusertoreceiveAppleTalktraffic.

Example

ThisexampleshowshowtoenabledynamicegressonVLAN55:

D2(rw)->set vlan dynamicegress 55 enable

vlan‐list SpecifiestheVLANsbyIDtoenableordisabledynamicegress.

enable|disable Enablesordisablesdynamicegress.

Enterasys D2 D2G124-12P User Manual

Questions and Answers: