Enterasys D2 D2G124-12P User Manual

clear radius accounting
D-Series CLI Reference 15-9
clear radius accounting
UsethiscommandtoclearRADIUSaccountingconfigurationsettings.
Syntax
clear radius accounting {server ip-address | retries | timeout | counter}
Parameters
Mode
Switchcommand,read‐write.
Defaults
None.
Example
ThisexampleshowshowtoresettheRADI USaccountingtimeoutto5seconds.
D2(su)->clear radius accounting timeout
Configuring 802.1X Authentication
Purpose
Toreviewandconfigure802.1XauthenticationforoneormoreportsusingEAPOL(Extensible
AuthenticationProtocol).802.1Xcontrolsnetworkaccessbyenforcinguserauthorizationon
selectedports,whichresultsinallowingordenyingnetworkaccessaccordingtoRADIUSserver
configuration.
Commands
serverip‐address Clearstheconfigurationononeormoreaccountingservers.
retries Resetstheretriestothedefaultvalueof3.
timeout Resetsthetimeoutto5seconds.
counter Clearscounters.
Note: To configure EAP pass-through, which allows client authentication packets to be forwarded
through the switch to an upstream device, 802.1X authentication must be globally disabled with the
set dot1x command (“set dot1x” on page 15-13).
For information about... Refer to page...
show dot1x 15-10
show dot1x auth-config 15-11
set dot1x 15-13
set dot1x auth-config 15-14
clear dot1x auth-config 15-15

Enterasys D2 D2G124-12P Specifications

General

Brand	Enterasys
Model	D2 D2G124-12P
Category	Network Router
Language	English