Enterasys D2 D2G124-12P

clear port txq
10-8 Port Priority and Rate Limiting Configuration
Parameters
Defaults
None.
Mode
Switchcommand,read‐write.
Usage
Queuescanbesetforstrictpriority(SP)orweightedround‐robin(WRR).IfsetforWRRmode,
weightsmaybeassignedtothosequeueswiththiscommand.Weightsarespecifiedintherange
of0to100percent.Weightsspecifiedforqueues0through7onanyportmusttotal
100percent.
Examples
Thisexampleshowshowtochangethearbitrationvaluesfortheeighttransmitqueuesbelonging
to
ge.1.1:
D2(su)->set port txq ge.1.1 10 10 10 10 10 10 10 30
Thisexampleshowshowtochangethealgorithmtostrictpriorityfortheeighttransmitqueues
belongingto
ge.1.1:
D2(su)->set port txq ge.1.1 0 0 0 0 0 O O 100
D2(su)->show port txq ge.1.1
Port Alg Q0 Q1 Q2 Q3 Q4 Q5 Q6 Q7
----- --- --- --- --- --- --- --- --- ---
ge.1.1 STR SP SP SP SP SP SP SP SP
clear port txq
Usethiscommandtoclearporttransmitqueuevaluesbacktotheirdefaultvalues.
Syntax
clear port txq port-string
port‐string Specifiesport(s)onwhichtosetqueuearbitrationvalues.Foradetailed
descriptionofpossibleport‐stringvalues,referto“PortStringSyntaxUsed
intheCLI”onpage 4‐1.
Onlyphysicalportscanbeconfiguredwiththiscommand.LAGports
cannotbeconfigured.
value0‐value7 Specifiespercentagetoallocate
toaspecifictransmitqueue.Thevalues
musttotal100percent.